Septic systems are most often found in rural areas of Dallas OR and will consist of a series of pipes connecting it to the home, a septic tank, a filtering system to separate the solid waste from the liquid and connecting pipes that drain off the liquid waste into the yard, in a designated area called the drain field. These systems are often inspected before septic installation and tested afterwards, to make sure that it is operating properly.
Ownership of a septic tank system in Dallas OR means that everyone understands the importance of having regular septic tank inspection and septic pumping to catch potential problems before they happen. All too often, nothing is done until the worst happens, like the tank developing a leak, or it backs up into an area away from the drain field. Two easy ways to avoid this from happening include monitoring what goes into it as waste and remembering its physical location to avoid accidents.
When there is a septic system installation, the area where the septic tank is placed should be noted so that no accidental driving or parking of a heavy vehicle can occur. While most tanks are buried deep enough to avoid this, as a general principle it should be avoided to prevent damage to the tank in the future.
What are the health department regulations for a Septic Tank in Dallas OR?
Septic systems require regular inspection and repair for proper functioning. The factors which influence the amount of work required in the maintenance are the size of the tank, the extent of its use by the household and the amount of water used in it. These factors influence how frequently the inspections are needed, but it must be kept in mind that even the best maintained septic systems require regular inspection.
The septic tank inspector is usually a qualified private contractor or a health professional with the local health administration. You can get in contact in one through your local health administration or the municipality. The health department will give you a list of the septic system inspectors who work locally. Most waste experts will require a fee for the job.
Locating the Tank
If you have purchased a new house, or have forgotten where the septic tank is, the first job is to locate the septic tank. Septic system inspectors take a fee for this job - so to save money and time you better find it yourself before the inspector comes.
If you are unable to do it yourself, the waste inspector has a number of methods to find a tank.
Sludge Judge and Tank Inspection
The waste expert inspects the condition and status of the solid waste in your septic system using a device called a Sludge Judge. It is a long pipe that is hollowed out to allow waste to enter it from the bottom. When inserted in the septic system waste, it takes a core sample of the solid waste. The inspector then visually inspects core sample to get an idea of the amount of solid and sludge contained in the tank and how decomposed they are. That then helps him decide whether to pump the tank or not.
The inspector also checks that the tank has remained watertight. He also checks the various components and parts of the system, along with the construction of the tank itself. Septic tank inspections are well worth the money if they help you find a problem early, before it becomes costly.
No one ever thinks about what happens to the waste and water once they have flushed the toilet, that is just a fact of life. For those of us whose homes are on urban water systems, we never will have to think about it. But, for those of us who own homes hooked up to septic systems, it is another maintenance issue that simply cannot be ignored. No matter how new or how old your home is, you need to have a regularly scheduled septic tank inspection and replacement costs may be avoided by spotting issues before they become emergencies.
How a Septic System Works
Most septic systems will include large holding tanks for storage, usually made out of plastic, but older ones may be steel or concrete. These tanks hold all of the household waste, especially the water and waste released when you flush the toilet. At some point the tank will be filled to its maximum level, and will need to have the waste disposed of in some fashion. This is usually done in one of three ways: by being pumped out, having bacteria or chemicals added that will break down and destroy the waste, or by allowing it to be drained into the soil through a leech field.
Like all hard working systems, eventually time will run its course, and maintenance will need to be done. Because septic systems are usually buried underground, it can be hard to tell when it is time for regular maintenance, and that is the main reason why regularly scheduled septic tank inspection and replacement assessments are so important. There can be a lot involved with doing even the basic maintenance on such a system, and being able to avoid major problems or even potential problems will insure that the cost of doing so will not skyrocket unnecessarily.
How Does an Inspection Work? How Often Should It Be Done?
Even if your particular septic system uses a leech field, or has decomposition additives used to break down the waste, it still should be pumped out on a regular basis, so that the service technicians can have a chance to inspect it for maintenance issues. Small tanks will require this more often than larger tanks, of course, and even if your system has water conservation measures in place, it still should be pumped out and inspected at least once every three to five years.
A good and thorough inspection should involve not only a visual check of the tank, connectors and drainage points, as well as the leech field, but the tank should be opened as often as possible, and the inside inspected. There are tests that field service agents can perform to test the function of the tank itself, like adding dye to the water to test for leaks. Any baffles or lids should also be checked for signs of wear and tear, as well as any connections and connecting pipes that the technician can reach readily.
Signs that Replacement is Needed
If you are in the market to purchase a home that is connected to a septic tank system, you should have a proper inspection done right away. Not all prior owners reveal the true facts about the system, or may not even know that it is close to being repaired or replaced. The more you know, the more prepared you will be for potential problems down the road. If the tank in the installed system is steel or concrete, you may want to negotiate getting it replaced right away.
Steel tanks rust, and may develop breaks and leaks that will eventually cause the leech field to be flooded. Concrete tanks break down over time, and if the area where the tank is buried is near the home, chances are something has been driven over it at some point. Even the smallest car has the potential to break down a concrete tank by exerting added pressure at a weak point. If water has reached the surface of the leech field, the leaks are extensive, and it is far past the point where any septic tank inspection and replacement check will help.
Regular septic tank inspections done by a professional plumber can help avert a major disaster caused by a septic system failure. Unfortunately, these are more common than you would think. Because the septic system runs underground, most homeowners tend to ignore it. However, failure to carry out regular inspections of the sewer system can be a health hazard and can also result in destruction of the surrounding property.
Before buying a new home, it is crucial to find out as much as you can about the system. Find out how old the system is and whether or not is has been regularly maintained. Better still, get an inspection done so that you do not start having problems as soon as you buy it and shift in.
What Causes Failure Of The Septic System?
There are several different factors that may cause the septic system to fail. Some of the more common reasons include:
• The septic tank is too small
• The diameter of the drainage pipes are too small
• The drainfield is not large enough or it may not leveled correctly
• The soils in which the system is installed is unsuitable
• Tree roots have entered into the pipes and are causing a blockage
• Faulty surface drainage
The problem is, more often than not, by the time the homeowner realizes there is a problem the damage done would already be quite extensive. To make matters worse, without the proper knowledge and equipment it is almost impossible to determine the cause of the problem. Leaving it unattended or trying to contain the damage by trial and error will only make matters worse. The only way to prevent extensive damage is by calling in a professional to try and resolve the issue.
How Septic Tank Inspection and Maintenance Is Done
When you call a professional plumber to inspect the septic tank and carry out the necessary maintenance, they will come with all of the latest tools.
First they will test for a blockage or seepage by using a sewer camera or by the fluorescent dye method. After determining the exact cause of the problem, they will then use the correct tool to correct it. A sewer snake is usually used to clear a stubborn blockage if that is what is causing the problems. A sewer snake, also called an electric eel, is a long, slender and flexible pipe that is sent into the drain pipe. Though flexible and slender, the pipe is tough enough to dislodge the clog. If the blockage is caused by tree roots that have invaded the pipe, these are usually cut by using a specially designed device called a drain rooter.
New septic system costs can be through the roof if you live in the wrong part of the country and unfortunately, there isn't much you can do about it. Unless you can do some of the work yourself or you have friends in the septic industry.
Septic systems do not come with price tags attached to them. So it becomes difficult to get a quote on the price of a new septic system, unless you ask the right questions and the right person to ask them to. Here we tell you how you should do that research, not only for a new septic system, but to also know of the costs of maintaining once it gets installed.
Estimating the Price of a New Septic System
The most important factors that make a difference in the price of a septic processing system are the construction material, the area where you live, the quality that you want, and the company that will install the system for you
The single biggest factor is the region or the area of your residence or installation. The prices range from $3,000 to $15,000.
Another important factor is the material used in construction. High-density polyethylene tanks are costlier than concrete tanks; they last longer too. Aerobic systems are even more costly.
To find the cost of permits that you need to build a septic processing system, you should call up the local Town Hall. To find the new septic tank costs in your neighborhood, ask your friends and neighbors about the cost of their systems. The local Realtors know a lot of the prices and the companies that are active in the area too.
Maintenance Costs of a Septic System
Your average system costs around $30-$750 to maintain. The standard gravity-fed systems need to be repaired and maintained once every 1-3 years, at a price of about $75-$300. Septic processing systems with sand and peat filters and the ones with wetlands construction cost around $50 to $1,700 per inspection and repair.
The average age of a septic system is about 20-40 years. If you take better care of your systems, doing regular inspection and maintenance, you will make them last longer. The difference can be decades. It's a worthwhile effort
Septic tank prices depend on various factors and it is not an easy task to make an accurate estimate of the price yourself. Licensed septic system installers are your best bet to make an accurate assessment of the price of the septic tank design you have in mind. But before you decide on the septic system you want, you have to first research it yourself. Here we tell you about the prices of septic tanks and how to find the best deals.
Septic System Prices for Various Components
Standard gravity-fed septic systems constructed at ground level for a three bedroom house cost around $1,500 to $4,000. Also, plastic vaults, thought smaller in size, cost more than the gravel ones.
Extra bedroom would require you to spend more because of the added capacity required of the tank and the system as a whole. Fine and silty soil also requires a larger drain field, which translates to higher costs. Good quality drain gravel is around $9 - $12 per ton, if it is not too far from the house. Drain field vaults are priced at around $25 to $40. Concrete tanks 1000 galloon in size cost around $500-$700 and that usually comes with free delivery within 50 miles of the contractor. 1250 gallon tanks cost about $600-$800. You should also know about the local laws regarding minimum tank size allowed for your house. Components like septic tanks, drain gravel, vaults and pipes do not have much variation. However, they can vary from state to state. So if you live near state lines, inquiry about the prices of those components in your neighboring state and, if they are cheaper, buy them there.
Pressure systems cost around $3,000 to $5,000+, but generally these are rarely installed by contractors. Some local regulations require an electrician to install the wiring for a pressure system, but in other places the installer can do that himself.
Septic System Maintenance Costs
Maintenance for a septic system needs to be done on a regular basis, so the cost of maintenance should be taken into account when you get a new septic tank. For a new drain field or mound-style septic system, annual maintenance charges range from $30 to $750. The pumping cost for standard gravity-fed tanks costs somewhere around $75 to $300 for every pumping, which is required once every 1-3 years. Usually, different septic contractors charge different rates, so make sure you shop around to find the best prices for what you need.
Go to my website to learn more about septic tank prices or maybe even septic tank risers. While you are there, make sure you download my free report discussing the top septic tank treatments.
There are multiple costs associated with a Septic System. I'll start with an explanation of the costs and give the actual estimates at the bottom:
Explanation of Septic Costs:
Cost to Pump Out the Septic Tank: Homeowners should have a licensed septic contractor pump out their septic tank every 3 to 5 years. If the tank is never pumped, then grease and other particles will flow into the leach field and clog the distribution pipes and the surrounding soil. Once that happens, he will need to have a new leach field installed at a cost of $10,000+.
Cost of Septic System Testing with Dye: Septic testing involves adding dye and running water in the house for approximately 30 minutes. Then, the contractor can check for flooding and see where the dye appears. There can be a variety of problems with a septic system, and these problems don't necessarily mean that the whole system must be replaced. This test will help the contractor diagnose the problem.
Cost to Remove Clog in Pipe To Tank: If the homeowner notices slow flushing toilets, he might assume there's a problem with the septic system, so they have a dye test done. If the dye test doesn't cause water and dye to show up in the leach field, then the problem might be a simple clog. A clog will require the assistance of a licensed plumber.
Cost of Complete Visual Inspection: Some septic contractors offer a complete visual inspection of the septic tank with a pumping. Needing this type of inspection is rare because problems with the actual septic tank will usually cause the leach field to fail, and once the leach field fails, you'll start noticing sewage in the yard.
Listing of Estimated Septic Costs:
Cost to Pump Out the Septic Tank: $150 to $250
Cost of Septic System Testing with Dye: $75 to $125
Cost to Remove Clog in Pipes to Tank: $50 to $250 (or more, if it's serious)
Cost of Complete Visual Inspection: $300 to $600
Septic Tank Inspection Oregon